Skip to content

Operating the wearable

The wearable is operated with a single button and gives feedback through an LED and a buzzer (vibration).

Button actions

  • Single press: show status
  • Long press (2 s): start calibration
  • Long press (5 s): switch off
  • Triple press: silent mode on/off

Status LED meanings

  • Solid green: connected and calibrated
  • Two short green flashes: not calibrated, ready for use
  • Blue: corrective vibration (bending or overextending)
  • Slow red pulse: silent mode is on
  • Breathing green: charging
  • Solid green (on the charger): fully charged
  • Red flashes: error, see Troubleshooting

Silent mode

A triple press switches between the two modes: Normal ⇄ Silent. In silent mode the buzzer is switched off and the red LED pulses slowly. Triple-press again to turn the feedback back on.

Switching off

Hold the button for about 5 seconds, past the single calibration buzz. Release when you feel fast, repeated buzzing and the red LED flashes.

The wearable also switches itself off after a period of inactivity to save the battery. Press the button, or put it back in the Pro Kit, to switch it on again.

Charging & battery

Charge the wearable with the USB-C cable, or place it in the Pro Kit. While charging, the LED breathes green; once fully charged it stays solid green.

When the battery is almost empty, the wearable buzzes rapidly and flashes red for a few seconds, then switches off.

For users with a beta SpineWise Pro Kit, the wearables only charge if the USB cable AND the charger are plugged in.

Troubleshooting

When the LED flashes red, there may be several causes:

  • the wearables are too far apart
  • the wearable's battery is empty
  • a wearable from another set is being used (e.g. collar 3 and belt 4)